2g	ingot for	0.6g wax weight
4g	ingot for	1.2g wax weight
5g	ingot for	1.5g wax weight
10g	ingot for	3.0g wax weight

Step One:

The objects have to be positioned within the indicated areas of the investment ring.

The wax wire should have a diameter of 8 gauge - no taper (3.0-3.5 mm)


The angle of the fixed objects to the vertical axis is approximately 20°

No part of wax pattern should be any closer than 5mm to edge of ring.

Step Three:

Carefully measure the weight of the wax patterns and sprues to calculate the required ingots from the above table.

Step Four:

Ingots and disposable plungers are NOT preheated.